Skip to content
Long Beach Marine Electric logo

Free tool

Marine Electrical Cost Estimator

Long Beach Marine Electric built this marine electrical cost estimator from published 2026 parts prices and Long Beach labor rates of $140–$200 per hour. Pick a job, tell it how easy access is and what condition the wiring is in, and you get an installed price range with the math shown, without a phone call.

2. How easy is access?
3. Wiring condition

Estimated installed cost

$140–$400

Diagnose a fault (pedestal trip, dead circuit)

Parts$0
Labor hours1.0–2.0 hrs
Labor at $140–$200/hr$140–$400

Parts basis: Usually no parts.

If you wait: Faults that leak current or run hot get worse, not better, and a tripping pedestal leaves the bilge on battery power only.
What this job involves →

Estimates use published 2026 parts prices and Long Beach labor rates of $140–$200/hr, adjusted for access and wiring condition. They are not quotes. Your electrician gives a fixed written price after inspecting the boat.

How the estimate is calculated

Estimate = parts + (typical hours × access factor × condition factor × labor rate). Parts come from published 2026 retail prices, listed under each job. Labor uses $140/hr for the low end and $200/hr for the high end, the range supported by 2026 marine-electrician shop rates (Trawler Forum survey) and the one published Long Beach rate ($175/hr, 2-hr minimum).

Access adds time when panels are behind cabinetry or wiring runs through tight engine rooms (×0.85 to ×1.4). Wiring condition adds time on older boats, where fixing one connection often exposes corroded wire behind it (×1.0 to ×1.35).

The figures match the worked examples in the marine electrician cost guide, the shore power installation cost guide and the lithium conversion cost guide.

Get an Exact Quote

Send the job and your marina. Callback the same day.

Step 1 of 2

Faster by phone: (562) 374-7233

Call (562) 374-7233 · Same-day callback