# Marine Electrical Cost Estimator | Free Boat Electrical Price Tool | Long Beach Marine Electric

> Free marine electrical cost estimator: pick a job, access and wiring condition to see an installed price range using 2026 parts prices and Long Beach labor rates.

URL: https://longbeachmarineelectric.com/tools/marine-electrical-cost-estimator/

Free tool

# Marine Electrical Cost Estimator

[Long Beach Marine Electric](/) built this marine electrical cost estimator from published 2026 parts prices and Long Beach labor rates of $140–$200 per hour. Pick a job, tell it how easy access is and what condition the wiring is in, and you get an installed price range with the math shown, without a phone call.

1\. What's the job?

2\. How easy is access?

 Easy: open access, small boat Typical: some panels or lockers to open Difficult: tight engine room, behind cabinetry

3\. Wiring condition

 Wiring looks clean, boat under 15 years old Some corrosion, boat 15–30 years old Green/black wire, boat 30+ years or DIY wiring

Estimated installed cost

$140–$400

Diagnose a fault (pedestal trip, dead circuit)

Parts

$0

Labor hours

1.0–2.0 hrs

Labor at $140–$200/hr

$140–$400

Parts basis: Usually no parts.

**If you wait:** Faults that leak current or run hot get worse, not better, and a tripping pedestal leaves the bilge on battery power only.

[What this job involves →](/boat-electrical-repair/)

Estimates use published 2026 parts prices and Long Beach labor rates of $140–$200/hr, adjusted for access and wiring condition. They are not quotes. Your electrician gives a fixed written price after inspecting the boat.

## How the estimate is calculated

**Estimate = parts + (typical hours × access factor × condition factor × labor rate).** Parts come from published 2026 retail prices, listed under each job. Labor uses $140/hr for the low end and $200/hr for the high end, the range supported by 2026 marine-electrician shop rates (Trawler Forum survey) and the one published Long Beach rate ($175/hr, 2-hr minimum).

Access adds time when panels are behind cabinetry or wiring runs through tight engine rooms (×0.85 to ×1.4). Wiring condition adds time on older boats, where fixing one connection often exposes corroded wire behind it (×1.0 to ×1.35).

The figures match the worked examples in the [marine electrician cost guide](/guide/marine-electrician-cost/), the [shore power installation cost guide](/guide/shore-power-installation-cost/) and the [lithium conversion cost guide](/guide/lithium-conversion-cost/).

Get an Exact Quote

Send the job and your marina. Callback the same day.

Faster by phone: [(562) 374-7233](tel:+15623747233)